https://www.rabbitscrewindustries.co.in Latest Products Fri, 15 May 2026 07:35:48 +0530 en-us https://www.rabbitscrewindustries.co.in https://www.rabbitscrewindustries.co.in/self-tapping-screw.htm https://www.rabbitscrewindustries.co.in/self-tapping-screw.htm Fri, 17 May 2024 00:00:00 +0530 A Self-Tapping Screw can tap its own hole as it is driven into the softer material like plastics, thin metal sheets or wood. Whereas it needs a pilot hole if the material is much harder like thick steel sheets, hard plastics, or metal surfaces. It is widely used in carpentry work, aluminum channels, sheet metals and other basic diy solutions.  https://www.rabbitscrewindustries.co.in/drywall-screw.htm https://www.rabbitscrewindustries.co.in/drywall-screw.htm Fri, 17 May 2024 00:00:00 +0530 A Drywall Screw is a self-tapping screw with more angular threads and a sharp pointed tip. As the name suggests, It is widely used on gypsum or drywall boards, and even on thin metal sheets and wood. It is easy to identify with its typical phosphate-black coating. A dimpler is always recommended for proper fixing of this screw.  https://www.rabbitscrewindustries.co.in/stainless-steel-self-tapping-screw.htm https://www.rabbitscrewindustries.co.in/stainless-steel-self-tapping-screw.htm Fri, 17 May 2024 00:00:00 +0530 They are designed to form a matching thread into the materials being joined. Recommended to be used in pre-drilled or punched holes in sheet metal and can also used with alumium, plywoods, soft and high impact plastics. Self tapping screws are designed for the purpose of 'self tapping' a thread into steel sections.  https://www.rabbitscrewindustries.co.in/metal-machine-screw.htm https://www.rabbitscrewindustries.co.in/metal-machine-screw.htm Fri, 17 May 2024 00:00:00 +0530 Machine screws are slightly smaller than bolts; machine screws also tend to be designated as such if the first tightening of the fastened joint is accomplished by turning the head of the screw. With a bolt, the primary tightening procedure is typically performed by rotating the nut, holding the bolt through a hole .